Specifications; Stihl Ak Battery; Temperature Limits; Sound Values And Vibration Values - Stihl SHA 56 Notice D'emploi

20 Specifications

Fault LEDs on the
battery
inserted into the
charger.
20 Specifications
20.1 Vacuum Shredder STIHL
SHA 56
– Approved battery: STIHL AK
– Blowing force: 8 N
– Maximum air velocity: 56 m/s
– Air throughput vacuum shredder 510 m³/h
– Volume catcher bag: 40 l
– Weight vacuum shredder without battery:
4.2 kg
– Weight blower without battery: 3.2 kg
The running time is shown at www.stihl.com/
battery-life.
20.2

STIHL AK Battery

– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: See rating label
20.3

Temperature limits

WARNING
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
above 50°C.
► Do not use the vacuum shredder or battery
below -20°C or above 50°C.
► Do not store the vacuum shredder or bat‐
tery below -20°C or above 50°C.
20.4 Recommended temperature
ranges
For optimum performance of the vacuum shred‐
der and battery, observe the following tempera‐
ture ranges:
– Charging: 5°C to 40°C
– Use: - 10 °C to + 40 °C
– Storage: - 20 °C to + 50 °C
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be reduced.
0458-828-9621-C
Cause
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
20.5
K-value (uncertainty) for sound pressure levels is
2 dB(A). K-value for sound power levels is 2
dB(A). K-value for vibration level is 2 m/s².
STIHL recommends wearing ear defenders.
– Sound pressure level L
measured according to EN 50636-2-100:
83 dB(A).
– Sound pressure level L
according to EN 50636-2-100: 81 dB(A).
– Sound power level L
in EN 50636-2-100: 94 dB(A).
– Vibration level a
EN 50636-2-100:
– Control handle: 0.8 m/s²
– Loop handle: 1.1 m/s²
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times when the power tool is
switched off and the times when it is switched on
but running under no load can be taken into
account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
20.6
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
Remedy
Sound Values and Vibration
Values
pA
pA
measured as specified
wA
measured according to
hv
REACH
English
(vacuum shredder)
(blower) measured
33