Medela Freestyle Flex Mode D'emploi page 30

Operating your breast pump (cont.)
Display elements
30
Bluetooth
indicator
Stimulation
phase indicator
Vacuum level
display
Power and battery status display
(flashing)
(flashing)
(flashing)
Battery display
freestyle
The power indicator (lightning symbol) indicates if the power adapter is
connected.
Æ If it lights up the power adapter is connected.
The battery display shows the state of the battery and its charging level.
Æ The display of all three bars indicates that the battery is full.
With decreasing battery capacity fewer bars appear.
Æ Two bars: approx. 75% of the capacity is remaining.
Æ One bar: approx. 40 % of the capacity is remaining.
Æ When the breast pump emits an audio signal and the last single bar is
flashing the battery is almost empty.
Æ After emitting a second audio signal while the outline of the battery
display is flashing, the breast pump will stop operation and switches off
completely after five seconds.
If all three bars and the outline of the battery display are flashing at the same
time, this indicates that the battery is overheated or defective.
See Troubleshooting (chapter 13) or call Medela Customer Service.
freestyle
The multifunction display shows,
depending on the device state, the
following information:
Power
• Session time in seconds (first
indicator
minute of pumping), then in
minutes
• L1 to L9 for the vacuum level
Expression phase
(along with the vacuum level
indicator
display)
• Pairing code (during Bluetooth
Multifunction
connection)
display
• Start delay in seconds
freestyle
11D-3
11-5
13
freestyle