Electrolux Y8SOB39X Notice D'utilisation page 174

TROUBLESHOOTING
Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Remove the metal ring and clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Attach the metal ring to the glass cover and install it.
Side lamp
Step 1 Remove the left shelf support to get access to the lamp.
Step 2 Use a Torx 20 screwdriver to remove the cover.
Step 3 Remove and clean the metal frame and the seal.
Step 4 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 5 Install the metal frame and the seal. Tighten the screws.
Step 6 Install the left shelf support.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
The appliance does not turn on or does not heat up
Possible cause
The appliance is not connected to an electrical
supply or it is connected incorrectly.
174/552
Remedy
Check if the appliance is correctly connected to
the electrical supply.