Publicité
Les langues disponibles
Les langues disponibles
BEFORE FIRST USE
Remove all accessories and
removable shelf supports from
the appliance.
5.2 First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
5.3 Initial preheating
Preheat the empty oven before the first use.
Step 1
Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.
5.4 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
150/552
Clean the appliance and the
accessories only with a micro‐
fibre cloth, warm water and a
mild detergent.
Step 2
Shake the test paper
to remove the excess
of water.
Place the accessories and the
removable shelf supports in
.
.
Step 3
After 1 min, check
water hardness with
the table below.
the appliance.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
Publicité
