Fitting Instructions - R&G LP0115 Instructions De Montage

Page | 5

FITTING INSTRUCTIONS


REMOVE THE BOLT ARROWED IN PICTURE 1 AND REMOVE RIDERS SEAT.

REMOVE THE PILLION SEAT OR SEAT COWL USING THE KEY.

REMOVE THE TWO BOLTS FROM UNDERNEATH THE ORIGINAL LICENCE PLATE
BRACKET AS ARROWED IN PICTURE 2.

REMOVE THE TWO BOLTS ARROWED IN PICTURE 3 AND GENTLY LOWER THE
ORIGINAL CABLE COVER/INDICATOR CLAMPING BRACKET.

REMOVE THE TWO PUSH RIVETS AS ARROWED IN PICTURE 5 (ONLY ONE SIDE
IS SHOWN).

REMOVE THE FIVE BOLTS FROM ABOVE AS ARROWED IN PICTURES 6 AND 7.

REMOVE THE FOUR BOLTS FROM BELOW AS ARROWED IN PICTURE 8.

GENTLY REMOVE THE LEFT HAND REAR SEAT COWLING.

GENTLY REMOVE THE PLASTIC CENTRE SECTION OF COWLING TO ALLOW
ACCESS TO THE BOLTS TO REMOVE THE ORIGINAL LICENCE PLATE BRACKET
(THE RIGHT HAND REAR SEAT COWLING CAN REMAIN IN PLACE TO SAVE
REMOVING THE KEY LOCK MECHANISM).

UNDO AND REMOVE THE TWO BOLTS ARROWED IN PICTURE 9.

UNDO AND REMOVE THE TWO BOLTS ARROWED IN PICTURE 10 USING THE
LONG SERIES ALLEN KEY THROUGH THE ACCESS HOLES IN THE SEAT CROSS-
MEMBER AS ALSO SHOWN IN PICTURE 10.

GENTLY LOWER THE ORIGINAL BRACKET AND REST ON THE REAR WHEEL.

DISCONNECT THE ORIGINAL INDICATOR AND LICENCE PLATE ILLUMINATOR
WIRING SOCKETS AS SHOWN IN PICTURE 11 AND REMOVE THE ASSEMBLY.

FIT THE NEW LICENCE PLATE ILLUMINATOR TO THE NEW LICENCE PLATE
BRACKET AS SHOWN IN PICTURE 12 (USE THE HEAT SHRINK TO PROTECT THE
WIRES) AND USING A SMALL AMOUNT OF SUPER-GLUE STICK THE LIGHT
SHROUD IN POSITION AS SHOWN IN THE TOP PICTURE.

IF REUSING THE ORIGINAL INDICATORS FIT TO THE NEW LICENCE PLATE
BRACKET (THESE WILL BE A TIGHT FIT THROUGH THE SLOT SO IT MAKES IT
EASIER TO FIT IF YOU USE A SMALL AMOUNT OF WASHING-UP LIQUID AND A
FLAT BLADED SCREW-DRIVER).
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 15
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
PICTURE 16
info@rg-racing.com