R&G LP0115 Instructions De Montage page 6


IF USING MINI INDICATORS USE THE FOUR DIAMOND SHAPED ADAPTORS.

PLACE THE RUBBER GROMMET INTO THE LARGER HOLE IN THE NEW LICENCE
PLATE BRACKET AS ARROWED IN PICTURES 14 AND 16.

FEED ALL THE WIRES THROUGH THE RUBBER GROMMET AS SHOWN IN
PICTURES 14 AND 16.

CONNECT THE INDICATOR AND LICENCE PLATE ILLUMINATOR PLUGS (PLEASE
Page | 6
NOTE YOU WILL HAVE TO REUSE THE ORIGINAL LICENCE PLATE
ILLUMINATOR PLUG SOCKET AND CUT AND SHUT THE WIRES USING THE
CONNECTORS SUPPLIED IN THE KIT).

PLACE THE LONGER BUTTON HEADED BOLTS WITH WASHERS THROUGH THE
TWO FRONT HOLES (THE HOLES FARTHEST AWAY FROM THE LICENCE PLATE)
IN THE NEW LICENCE PLATE BRACKET AS SHOWN IN PICTURE 13.

PLACE THE TWO LONGEST SPACERS OVER THE EXPOSED END OF THE BOLTS
AS SHOWN IN PICTURE 13.

PLACE THE TWO SHORTER BUTTON HEADED BOLTS WITH WASHERS
THROUGH THE REMAINING HOLES IN THE NEW LICENCE PLATE BRACKET.

PLACE THE TWO ANGLED SPACERS OVER THE EXPOSED END OF THE TWO
BOLTS (WITH THE ANGLED FACE AGAINST THE NEW LICENCE PLATE
BRACKET).

OFFER THE WHOLE ASSEMBLY UP TO THE MOTOR CYCLE AND USING THE M5
NYLOC NUTS AND WASHERS FROM KIT SECURE THE NEW LICENCE PLATE
BRACKET INTO POSITION AS SHOWN IN PICTURE 15 (ON THE TWO REARMOST
NUTS YOU WILL HAVE TO USE A 8mm SPANNER (TIGHTEN ALL THE BOLTS
GRADUALLY AND EVENLY).

IT IS GOOD IDEA TO TEST ALL LIGHTS AT THIS STAGE.

REFIT ALL FAIRING PANELS AS ORIGINAL.

REFIT LICENCE PLATE (IT MAY REQUIRE DRILLING).

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT
FAR DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE
OF THE LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD
AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO
CHECK FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO
CHECK THIS COULD RESULT IN SERIOUS INJURY.

REFIT BOTH SEATS.

DEPENDING ON LOCAL LAWS, ATTACH ENCLOSED REFLECTOR IN AN
APPROPIATE LOCATION.

TEST THE LICENCE PLATE ILLUMINATOR AND ALL LIGHTS BEFORE RIDING.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 04/04/2012 (NSY)
CONSUMER NOTICE
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email: info@rg-racing.com