Working with the carver:
Do not switch on the unit when it is under load (axial pres-
sure). Do not work without protective glasses.
1. Firmly secure the work piece.
2. Turn on the unit at the switch 1 (Fig. 1).
3. Hold the unit such that the ventilation slots 5 (Fig. 1)
are not covered.
4. Guide the unit with light hand pressure (Fig. 4) and
avoid strong pressure. You can achieve cleaner work
results if you let the unit cut through the material by
itself without much pressure.
Immediately switch off the machine and allow it to cool
down if it has overheated.
Always work moving away from the body and never hold
your fingers or hand (Fig. 3) in the direction of cutting. You
could hurt yourself if you slipped. Work as shown in Fig. 4!
Trace or draw the design motif before starting the work on
the work piece and cut it out roughly.
You can find technical books and templates at your books-
tore. You will also find usual information about materials
and working techniques in our "Manual for Creative Model
Makers" with part number 28 996.
Care and maintenance
Always pull out the mains plug before any work!
Always ensure that the ventilation slots are clear.
Check the mains cable at regular intervals for damage.
Have it replaced by a technician if it is damaged.
No special maintenance is required for your motorised car-
ver apart from occasional cleaning. If you follow the notes
in these operating instructions, the unit will give you long,
reliable, safe and valuable service.
Please do not dispose of the device in domestic waste!
The device contains valuable substances that can be recy-
cled. If you have any questions about this, please contact
your local waste management enterprise or other corre-
sponding municipal facilities.
WARNING!
WARNING!
Note:
WARNING!
WARNING!
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Article No.:
In sole responsibility, we declare that this product conforms
to the following directives and normative documents:
EU EMC Directive
EU Machinery Directive
Date: 10.11.2014
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with the
signatory.
MSG
28644
2004/108/EC
DIN EN 55014-1 / 05.2012
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 03.2014
2006/42/EC
DIN EN 60745-1 / 01.2010
- 7 -