Programming Of The Powersteam Steam Temperature; Clock Programming - Gaggia Milano Deco Evo Serie Mode D'emploi Et D'entretien

English
During the programming of
a tea the group functioning
and the tea dispensing are
disabled.
7.3 Programming of the powersteam
steam temperature
It is possible to change the steam temperature following
the sequence described below:
Press key T5 of coffee unit 1 and keep pressed down for
over 5 seconds and check that all the keyboard led
indicators come on.
Press the T8 powersteam button within 30 seconds
(programming time-out).
66
In this way, the machine starts dispensing steam.
Once the desired temperature is reached (measured by
using an external probe), press the T8 button again to stop
steam dispensing. In this way, the new steam temperature
value is saved. The light relating to the programmed
button turns off.
Press key T5 to immediately escape from the programming
stage.
During
programming the group
functioning and the tea
dispensing are disabled.
7.4

Clock programming

Press the T5 button of the first group for more than 5
seconds.
Once in the programming mode press the T5 button again
to move to the clock synchronization.
When the display shows "Clock adjust" press the T3
button to enter the sub-menu for the setting.
The display shows:
the steam