Gaggia Milano Deco Evo Serie Mode D'emploi Et D'entretien page 55

Before proceeding with installation check that:
• there are no bumps, signs of knocks or deformities.
• there are no damp patches or marks which could lead one
to assume that the packaging has been exposed to the
elements
• there are no signs of tampering
Once one is satisfied that transportation has been
correctly effected proceed with installation.
Make sure the machine is
installed on a flat surface
capable of
weight (see
Specifications"
and take care of leaving a
clear area of at least 30 cm
around the machine.
The least height of the
support's top must be
110cm (The higher surface
of the appliance
however be at least 1,5 m
from the ground level).
the maximum
inclination of the supporting
surface must NOT exceed 2°.
Proceed with installation following the instructions according to the
sequence as described below.
bearing its
"Technical
chapter)
shall
angle of
Only for NSF high raised
groups version. Replace
the appliance feet with the
ones supplied.
English
55