Fitting Instructions - R&G LP0150BK Mode D'emploi

Page | 4

FITTING INSTRUCTIONS


Remove the four bolts arrowed in picture 1 and remove the original cable cover/under-
tray.

Remove the two forward bungee hook bolts that secure the seat as shown in picture 2.

Remove the seat.

Remove the two rearward bungee hook bolts as shown in picture 3 and remove the top-
hat shaped spacer as shown in picture 4 (for use with mini indicators if required).

Remove the rear cowling.

Disconnect the wiring socket arrowed in pictures 5 and 6.

Remove the four bolts arrowed in picture 5 and remove the original licence plate bracket.

For wiring connection we suggest cutting and reusing the original plug socket (please see
below).

With the original licence plate bracket removed from the motorcycle cut the wiring loom
approximately at the arrow in picture 7.

Strip the cable shroud back to allow the use of the scotch block electrical connectors from
the new rear light assembly. See below for wiring.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 11
PICTURE 13
R&G Racing
PICTURE 12
PICTURE 14
www.rg-racing.com Email:
4
info@rg-racing.com