Volvo Penta ACP Instructions De Montage page 4

This kit contains:
Designation
Drill template
Transom unit
Washer, M10
Lock nut, M10
Washer (M50, plastic)
Grommet nut (M50)
Corrosion Protection Module (CPM)
Washer (bonding, M8)
Bonding cable kit
Multilink breakout
Fuse kit
Installation instruction
to be bought separately
Screw (to fasten the drilling template)
Screw (to fasten the CPM)
Washer (to fasten the CPM)
Multilink cable
Standard cable*
Extension cable**
Y-split cable**
13 mm (1/2") drill bit
Installation equipment/Special tools
Hole saw, diameter 52 mm (2")
VODIA Diagnostic tool
Extras
Drive bonding cable kit (TRIPLE/QUAD only; TRIPLE requires 1 extra kit, QUAD requires 2 extra kits)
Sealant (plastic hull only)
Corrosion protection (Aluminum hull only)
*) This cable is only needed for engines with two diagnosis connectors.
**) These cables are only needed for engines with a single diagnosis connector
Read the entire instruction before installation.
Important! Make sure that the main switch is off.
note! If the IPS drive is equipped with any other corrosion protection, it must be disabled
for the Volvo Penta ACP to function properly.
Quantity pos.
1 a
1 c
4 -
4 -
1 -
1 -
1 d
2 -
1 e
1 f
1 g
1 -
2 b
3 -
3 -
1 h
1 i
1 j
1 k
1 -
pos. in Fig.
I:2
III:1
III:1
III:1
III:1
III:1
I:3
III:1
III:1
III:4a
III:4a