Technical Data - Batavia THOR MULTISAW Mode D'emploi

Problem
The actual
3.
cutting depth is
less than the
set cutting
depth.
The fitted tool
4.
slips.
The fitted tool
5.
doesn't cut in a
straight line.
Product does
6.
not reach its
full power.
Unsatisfactory
7.
result.
Excessive
8.
vibration and
noise.
The product
9.
overheats.
Product stops
10.
suddenly.
Too much
11.
sparking or
motor runs
irregularly.

12. Technical data

Nominal voltage/frequency:
. . . . . . . . . . . . . . 230 – 240 V ~, 50 Hz
Nominal output: . . . . . . . . . . . . . 710 W
Protection class: . . . . . . . . . . . . . . . . II
Idle speed n /rated speed n: . . . 5300 min
0
Cutting depth: . . . . . . . . . . .
Weight: . . . . . . . . . . . . . approx. 2.6 kg
Multi Material (MM) saw blade
Dimensions: . . . . . . Ø 89 × Ø 10 × 1.4 mm
Number of teeth/segments: . . . . . . . 24 T
Material:. . . . . . . . Wood(HS/HW),plastic
Max. speed permitted: . . . n
7063051-Thor-Compact-Ma-1804-30.indb 19
Possible cause
There is a build-up of saw-
dust blocking the base plate.
The fitted tool is not secure
enough.
The fitted tool is dull.
The fitted tool is not properly
mounted.
The product is not being
guided properly.
Vents are blocked.
The fitted tool is worn out.
The fitted tool is not suitable
for the task.
The fitted tool is blunt or
damaged.
Screws/nuts are loose.
Clogged vents.
Product is overloaded.
Product is overloaded.
Dirt in motor or worn carbon
brushes.
-1
. 26 mm
max
7000 min
-1
max
Solution
Shake the saw to remove the
sawdust.
Connect a dust extractor (see chapter
"Connecting the dust extractor").
Remove the fitted tool and put it back
in (see chapter "Inserting and chang-
ing the fitted tool").
Mount a new, sharp fitted tool.
Check whether the fitted tool has
been properly mounted.
Use the cutting line guide.
Clean the vents.
Replace it with a new, sharp fitted
tool.
Use a suitable fitted tool.
Replace it with a new, sharp fitted
tool.
Tighten the screws/nuts again.
Clean the vents.
Only use the product as intended.
Remove the product from the work
piece and switch it on again.
Every individual part is an important
component of the double safety insu-
lation and must not be repaired by the
user. Have it checked by a
professional.
Diamond cutting disc
Dimensions: . . . . . .Ø 89 × Ø 10 × 2.0 mm
Material:. . . . Tile, marble, granite, concrete
Max. speed permitted: . . . . . . 8000 min
Top operating speed: . . . . . . . . . 37 m/s
Laser
Class: . . . . . . . . . . . . . . . . . . . . . . 2
Standard: . . . . . . . . . . EN 60825-1:2014
Wavelength λ: . . . . . . . . . . . . . 650 nm
Output energy P : . . . . . . . . . . . ≤ 1 mW
0
Battery: . . . . . . . 1 × 3 V⎓, Li-Ion, CR2032
English
-1
19
04-06-18 11:55