Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
13. Noise/vibration information
WARNING!
Wear ear protection!
Attention!
The vibration level will change according to
the use of the power tool and can be above
the value stated in these instructions in
some cases.
The vibration load may be underestimated if
the power tool is used in this way on a regu-
lar basis. Attempt to keep the stress associ-
ated with vibrations as small as possible.
Exemplary measures that can reduce vibra-
tion stress include wearing gloves when
using the tool and limiting the amount of
time you use it. At the same time, all parts
of the operating cycle must be accounted
for (e.g. times when the power tool is turned
off and when it is turned on, but not operat-
ing under load).
The vibration level stated in these instruc-
tions was measured according to an EN
60745 standard measurement method and
can be used for comparing equipment. The
specified vibration emission level may also
be used to initially assess the exposure.
Noise level determined in accordance with
EN 60745. The A-weighted noise level of the
power tool normally amounts to:
20
7063051-Thor-Compact-Ma-1804-30.indb 20
Noise emission
– when idle
Sound pressure level L
pA
Sound power level L
: . . . . . .100.5 dB(A)
WA
Uncertainty K: . . . . . . . . . . . . . 3 dB(A)
– when cutting ceramics
Sound pressure level L
pA
Sound power level L
: . . . . . 108.2 dB(A)
WA
Uncertainty K: . . . . . . . . . . . . . 3 dB(A)
Vibration values
– when cutting wood
Front handle a
,W:
h
. . . . . . . . . . . . . < 2.5 m/s
Rear handle a
,W:
h
. . . . . . . . . . . . .< 2.5 m/s
Uncertainty K: . . . . . . . . . . . . .1.5 m/s
Front handle a
:
h
. . . . . . . . . . . . . < 2.5 m/s
Rear handle a
:
h
. . . . . . . . . . . . .< 2.5 m/s
Uncertainty K: . . . . . . . . . . . . .1.5 m/s
Vibration and noise reduction
Limit the operation time, use low vibration
and quiet operating modes and wear per-
sonal protective equipment to reduce
vibration and noise impact.
The following measures help to reduce
risks caused by vibration noise:
Only use the product as intended and
1.
as described in these instructions.
Make sure that the product is not faulty
2.
and is well-maintained.
Use the correct fitted tools for this prod-
3.
uct and ensure that they work without
any problems.
Hold the product firmly by the handles/
4.
gripping surfaces.
Service the product according to the
5.
instructions and ensure enough lubrica-
tion is used (if applicable).
Plan your workflow in such a way that
6.
the use of products with a high vibration
value is spread over a longer period of
time.
: . . . . . 89.5 dB(A)
: . . . . . 97.2 dB(A)
(1.226 m/s
)
2
2
(1.854 m/s
)
2
2
2
(1.940 m/s
)
2
2
(2.073 m/s
)
2
2
2
04-06-18 11:55
Publicité
Table des Matières
