Eurofred 3CSA0013 Mode D'emploi page 45

those related to the maximum temperature
and safety.
- ABC: this mode is identical to the Manual mode
except that the collector pump will be
activated only when the temperature of the
collector exceeds ' T ABC ' programmed in
the relevant installer parameter.
RESET
In order to reset the device, press the key labelled as
' RESET ' located behind the removable door; DO NOT USE
PINS OR NEEDLES.
INSTALLER PARAMETERS
To access the installer parameters press the '  ' key.
Entering the Password
The display will show 'PWD 0000' with the leftmost digit
flashing thus requesting for the correct password.
In order to set the 4 password digits use the '  ' or '  '
key; by pressing the '  ' key, the current digit is confirmed
and the flashing is transferred to the following digit.
After confirming the last digit, the '  ' key will give access
to the installer parameters.
The initial password is factory set as '0000'.
Modifying the Password
In order to modify the stored password, first press the '  '
key, then proceed as follows:
PRESS THE ' MENU ' KEY.
THE DISPLAY SHOWS
' PWDH0000 '.
ENTER THE CURRENT PASSWORD.
(same procedure described above)
THE DISPLAY SHOWS
' PWDN0000 '.
45



