Setting The Air Temperature; Setting The Humidity Level; Food Holding Guide - Hatco Flav-R-Savor FSD-1 Manuel D'installation Et D'utilisation

Masquer les pouces Voir aussi pour Flav-R-Savor FSD-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Setting the Air Temperature

1. Press the
key to enter temperature mode ("tSP" will
appear on the cabinet temperature display).
2. Press the
key again to show the current temperature
setting.
3. Press the
key or
temperature. The temperature range is 80°–195°F
(27°–91°C) in single degree increments. See the "Food
Holding Guide" in this section for recommendations.
4. After the desired temperature is set, wait 15 seconds without
pushing any keys for the cabinet temperature display to
return automatically to operational mode.

Setting the Humidity Level

1. Press the
key to enter humidity mode ("hSP" will
appear on the cabinet temperaturE display).
2. Press the
key again to show the current humidity
level.
3. Press the
key or
humidity level. Humidity range is 1 through 5 (1 is the
lowest amount of humidity and 5 is the highest). See the
"Food Holding Guide" in this section for recommendations.
4. After the desired humidity level is set, wait 15 seconds
without pushing any keys for the cabinet temperature
display to return automatically to operational mode.
NOTE: Temperature and humidity settings may vary depending
upon product make-up and consistency. The CABINET
TEMPERATURE display shows the lowest temperature
point inside the cabinet, not the product temperature.

Food Holding Guide

Type of Food
Biscuits
Chicken Pieces (Fried)
Croissants
Fruit Pies
Onion Rings
Pizza — Thick Crust
Thin Crust
Pretzels
Wrapped Sandwiches
NOTE: All times and settings are recommendations only and may vary depending on product preparation, cooking time, and
internal food temperature.
Form No. FSDM-0119
key to reach the desired
key to reach the desired
Maximum
Holding Time
2 Hours
4 Hours
4 Hours
3-1/2 Hours
1/2 to 1 Hour
1 Hour
1 Hour
3 Hours
2 Hours
Setting the Humidity Level
The capacity of the water reservoir permits uninterrupted
operation for approximately 4–8 hours, depending on the
settings and how frequently the door is opened. When "LO
H2O" is flashing on the CABINET TEMPERATURE display,
add water to the reservoir. The water reservoir refill capacity is
approximately 96 ounces, or 3 quarts (2.8 liters).
ELECTRIC SHOCK HAZARD: Overfilling can cause
electrical shock. Water reservoir is full when "LO H2O"
stops flashing on CABINET TEMPERATURE display. Stop
filling when "LO H2O" stops flashing on display.
Humidity
Setting
3
130–140
5
1
4
1
4
5
4
4
11
OPERATION
WARNING
Temperature
°F
°C
55–60
175
80
140
60
140
60
175
80
185
85
180
82
140
60
180
82

Publicité

Chapitres

Table des Matières
loading

Table des Matières