Fitting Instructions - R&G IF0001SI Instructions

Page | 5

FITTING INSTRUCTIONS


Remove the speedo drive cable using a Phillips screwdriver, as shown in picture 1.

Unhook the cable along its path from all the cable clips.

Remove the small Phillips screw in the end of the odometer dial and remove the plastic knob, as
shown in picture 2.

Remove the two domed headed nuts from the rear of the speedometer and gently begin to remove
the plastic cover, as shown in picture 3.

Remove the two bulbs by gently pulling the cables and rubber mounts from their holes, as shown
in picture 4.

The speedometer can now be removed by gently releasing it from the rubber mount from the top
side, as shown in picture 5. The speedometer drive cable will come out with it.

Remove the plastic cover for the rev counter in the same way. There are three additional
connectors to unscrew, as shown in picture 6.

Remove the two large rubber mounts from the aluminium bracket and put to one side, as these will
be required when re-fitting.

Remove the two small bolts that secure the instrument panel lights in place, as shown in picture 7.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 15
PICTURE 17
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
PICTURE 16
R&G Racing
www.rg-racing.com Email: info@rg-racing.com