Set-Up And Operation; Safety Features - EUROM Safe-t-Heater 1500 Manuel D'utilisation

Set-up and operation

Switch the heater on by turning the mode selector dial to

one of three positions. The light at the front will turn on.
500 = Heating at 500W
1000 = Heating at 1000W
1500 = Heating at 1500W
The thermostat serves to maintain a constant room

temperature.
To set the desired temperature, turn the thermostat dial
to its maximum position (clockwise as far as it goes).
Set the mode selector dial to 500, 1000 or 1500.
Once the desired temperature is reached, turn the thermostat dial back slowly
until you hear a click. This causes the heater to switch off. The heater will now
automatically switch on and off to maintain the set temperature.
The pressure switch between the thermostat and mode selector dial turns on

the oscillating function. Push in to operate the oscillating function and push
again (to release) and the function will switch off.
To switch the heater off, first turn off the oscillating function off, then set the

power dial to '0' (off). Unplug.

Safety features

Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, set the mode selector dial to 'OFF' (off), unplug and allow
the heater to cool down. Remove and/or amend the cause of overheating and reuse
the heater as normal. If you cannot find a cause and overheating recurs, stop using
the heater, and take it in for inspection/repair.
30