EUROM 1500 RC Mode D'emploi page 17

1. Drill a hole with a diameter of 8 mm.
2. Place the key bolt with hanging eye in the
hole (Figure 7, pos. 1).
3. Attach a karabiner hook (Figure 7, pos. 2) to
the ring of the hanging chain (50 cm) and the
key bolt with hanging eye (Figure 7, pos. 1).
4. Attach a karabiner hook (Figure 7, pos. 4) to
the other end of the hanging chain (50 cm)
(Figure 7, pos. 3) and the hanging eye of the
device (Figure 7, pos. 5).
Hanging on a frame
1. Place the additional hanging chain (30 cm)
(Figure 8, pos. 2) through the ring of the
hanging chain (50 cm) (Figure 8, pos. 3) and
over the frame (Figure 8, pos. 4).
2. Attach a karabiner hook (Figure 8, pos. 1) to
both ends of the additional hanging chain (30
cm) to close the loop.
3. Attach a karabiner hook (Figure 7, pos. 4) to
the hanging chain (Figure 7, pos. 3) and the
hanging eye of the device (Figure 7, pos. 5).
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted in the right place.
Do not use an extension cable, this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 1500 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
Figure 7
Figure 8
17