Set-Up And Operation - EUROM C.U. 2000 Manuel D'utilisation

aforementioned warnings in this manual.
Check if the control switch is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240 V socket. To

prevent the circuit overloading, check that no other appliances are connected to
the same group.

Set-up and operation

Activate the heater by switching the main switch to I (ON).The display lights up and
shows the ambient temperature. If you take no further action the light on the display
switches off after 10 seconds.
Mode:
Pressing the MODE button will start the heater. Every time you press the MODE
button, the heater will sequentially select another function:
(fan) > LO > HI > THERM.\ ECO >
Fan only

LO: low power (1,350 W) with thermostat operation -

without sensor function
HI: high power (2,000 W), with thermostat

operation - without sensor function
THERM.\ECO sensor operation, high power with

thermostat function (ECO). If the sensor detects no-
one for 5 minutes, the heater will automatically
switch off (standby). It will resume operation on its
old settings if someone is detected within 2 metres of
the heater. You will then hear a buzzer.
(frost protection) The heater will try to keep the

space frost-free. The thermostat is permanently set
to 7°C and the sensor will not operate.
Thermostat:
The thermostat is set standard to 24 degrees. Using the
+ and - buttons, you can set the thermostat higher or lower respectively: from 5 to
32°C. Once the set temperature has been reached, the heater will switch itself off;
the fan will cool for another 30 seconds and then it too will stop. If the temperature
drops, the heater will switch itself on again. The display will continue to show the
set temperature. The display will also indicate 'THERM' under the mode to show
that the thermostat is working.
Oscillation:
Press OSC to start, and then press again to switch off.
Timer:
Press (during operation) on 'Timer' to set the amount of time before the heater
should switch itself off: the timer display will flash for a few seconds. While it is
(frost protection) >
30
etc.