Location And Connection; Set-Up And Operation - EUROM Safe-t-Heater 2000 Tower Manuel D'utilisation

Location and connection

 Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 Check whether the Main switch is set to OFF (O).
 Fully extend the power cord and plug into a suitable 220-240V socket. To
prevent the circuit overloading, check that no other appliances are connected to
the same group.

Set-up and operation

 Activate the heater by switching the main switch to I (ON).The display lights up
and shows the ambient temperature. If you
take no further action the light on the
display switches off after 30 seconds.
 Push 1 x the ON/OFF and ventilator button.
The ventilator starts and the other
functions can be selected.
 Heating. 1 x push = 1000Watt, 2 x push =
2000Watt, 3 x push = back to ventilator
only.
 Oscillation. Push to start, and then push
again to switch off.
 Timer. Push the button the number of hours after which the heater must switch
itself off (from 0 to 8 hours).
 Thermostat buttons. After pushing, "AUTO" is shown in the display. You can now
set the desired temperature, from 15 to 35°C. With '+' you increase the desired
temperature, and with '-' you
decrease the desired temperature.
The display shows the set
temperature for 3 seconds and
then switches back to the ambient
temperature. When the
temperature drops to more than 2°
below the desired temperature the
heater will operate at 1000W.
When it drops to more 3° below
the desired temperature, the heater will operate at 2000W. If the ambient
temperature is higher or equal to the set temperature, the heater will switch off.
 Pushing the ON/OFF and ventilator button again simultaneously will switch off
all functions. The ventilator will then cool down for 30 seconds. Then switch the
main switch to 0 and pull the plug out of the socket.
30