EUROM 1500 RC Mode D'emploi page 20

1. Make sure the ON/OFF switch is in the OFF position (Figure 9, pos. 4).
2. Disconnect the power plug from the power outlet (Figure 9, pos. 1).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries (Figure 10) from the remote control.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
infrared lamp, electric cable and/or electric plug is damaged, it should be replaced by the
manufacturer or its service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
The device becomes very hot. Make sure the device is unplugged and
completely cooled down.
CAUTION
Do not use:
•
•
•
Prevent water from entering the device. Do not immerse any part of the device
in water or other liquids.
It is recommended to clean the device after each use and prior to storage.
1. Carefully vacuum the openings to remove dust and dirt.
2. Wipe the device with a damp, clean, soft, lint-free cloth or a soft brush.
3. Let the device dry completely prior to use and storage.
Disposal
At its end of life, discard the device according to the local laws and regulations, or deliver the
device to your supplier. Remove the batteries from the remote control for separate disposal.
Attachments
The CE declaration can be found at the end of this manual.
20
scouring pads;
hard brushes;
flammable, aggressive or chemical cleaning products.