Installing The Heater - EUROM TH2003 Mode D'emploi

INSTALLING THE HEATER

Wall mounting:
 The housing of the heater (1) must be at least 30
cm from the ceiling, 50 cm from side-walls and 1.80
m above the floor.
 The patio heater must be affixed to a sturdy wall
made of stone or cement. Never attach to walls
made of wood or other flammable material! Attach
using the bracket supplied; do not use any other
supports or attachments!
 Drill four holes in the correct places for the plugs
and attach the wall support to the wall using the
screws. The curved part of the plate must be
uppermost and the 'keyhole' must be located at the
bottom of the support. The wall support must be
horizontal.
 Hang the heater onto the wall support. The bracket
at the back of the heater unit must fall into the curved part of the wall support; the attachment
screw (7) must be placed into the round part of the 'keyhole' on the wall support and then
pushed gently downwards until the patio heater is firmly affixed.
 Check that the patio heater is attached firmly and fully horizontally before use.
Assembling the stand (only S version):

Place the bottom section of the stand (9, with the fastening plate) on the base (8), in
such a way that the screw holes are aligned. Insert the 3 bolts through the double holes and
tighten them firmly. Place the protective cover over the screw connection (for that reason,
remove the cable holder for a moment)..

Push the central section of the stand (10) over the bottom part (9) and fasten it in place
with one of the screws. You then attach the top part of the stand (11, with the compression
coupling) to the middle section in the same manner with a screw.

Insert the thinner, adjustable section of the stand (12) as far as you wish into the grey
part of the compression coupling on top of the stand. Slide the locking ring down over the
thin section of the stand and screw it firmly to the grey compression coupling.

Unscrew the mounting screw (7) almost completely out of the mounting bracket. Place
the head of the terrace heater over the top of the adjustable stand section in such a way that
the screw falls precisely into the hole in the stand. Now tighten the screw firmly (the screw
must disappear into the thin section of the stand and may not protrude!). The thin section of
the stand can rotate 360°, enabling the head of the terrace heater to point in any direction.
The electrical cable can be secured in the cable holders on the stand.
Check that all connections are completely secure and that the terrace heater is securely
positioned before using it.
The terrace heater must be placed at a distance of at least 1 metre from the nearest wall.
The box with the radiator lights must be at least 30 cm from a ceiling and 1.80 metres
above the ground. The terrace heater must be placed firmly on an even and completely
horizontal surface.
PATIO HEATER FUNCTIONS
 Point the head of the terrace heater in the correct direction.
 If the terrace heater is fitted with a base the height of the heating head can be adjusted by
unscrewing the locking ring, pushing the curved section higher or lower, and then securing it
again.
10