Nailer Operation; Methods Of Operation - Metabo HPT NV 75A5 Manuel D'instructions Et De Sécurité

NAILER OPERATION

Read section titled "SAFETY" (pages 3 – 7).
DANGER
Operators and others in work
area MUST wear safety
glasses with side shields
which conforms to ANSI
Z87.1 specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
Only person who have read
and understand this MANUAL
should operate the Nailer.
NEVER point tool at yourself
or others in work area.
Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
Know and understand what trigger system
you are using.
Please read and understand "Methods of
Operation" below.
Inspect the Nailer before operating to
determine actuation system.
Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
Do not drive nails into other nails; nails can
ricochet and hurt someone.
Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
000Book̲NV75A5̲US̲metabo.indb 15 000Book̲NV75A5̲US̲metabo.indb 15
Never use Nailer which is defective or
operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise moving it
to another location;
4) handing it to another person;
5) removing the screw;
6) changing switching device;
7) performing any maintenance
or repairs;
8) clearing a jam;
9) Nailer is outside of the operator's
supervision or control;
10) removing nails from the magazine;
11) adjusting nailing depth;
12) attaching or removing the nose cap;
13) turning the top cover;
14) installing or removing the hook; and
15) a xing the hook.
This metabo HPT nailer is equipped with a nailer
operation switching device.
Use SINGLE SEQUENTIAL ACTUATION MECHANISM or
CONTACT ACTUATION MECHANISM in accordance with
the work to be performed.
Explanation of the various nailing operations
SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next,
pull the trigger to drive the nail.
After nailing once, nailing will not be possible again
until the trigger is released and pressed again.
CONTACT ACTUATION MECHANISM: First, press
the push lever against the wood; next, pull the trigger
to drive the nail. Or,
pull the trigger; next, press the push lever against the
wood to drive the nail.
If the trigger is held back, a nail will be driven each
time the push lever is pressed against the wood.

METHODS OF OPERATION

This Nailer is equipped with the push lever and does
not operate unless the push lever is depressed (upward
position).
There are two methods of operation to drive nails with this
Nailer.
They are:
1. Intermittent operation (Trigger fi re):
2. Continuous operation (Push lever fi re):
English
Screw
15
2018/09/21 15:04:29 2018/09/21 15:04:29