Metabo HPT NV 75A5 Manuel D'instructions Et De Sécurité page 12

English
If abnormal operation occurs, stop using the Nailer and
contact a metabo HPT authorized service center immediately.
(1) DISCONNECT AIR HOSE FROM NAILER.
REMOVE ALL NAILS FROM NAILER.
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them.
THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Trigger
Push Lever
(2) REMOVE ALL NAILS FROM NAILER.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE TOOLS TO OPERATE
SWITCH.
Set the switching device to the upward position
(to set to SINGLE SEQUENTIAL ACTUATION
MECHANISM).
(Set the switching device to the upward position
completely as shown in the diagram. Otherwise, it will
not operate properly.)
Switching device
12
000Book̲NV75A5̲US̲metabo.indb 12 000Book̲NV75A5̲US̲metabo.indb 12
Do not connect
air hose
Upward position
(3) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm
Connect the air hose.
THE NAILER MUST NOT LEAK AIR.
(4) Remove the fi nger from the trigger and press the
push lever against the wood.
THE NAILER MUST NOT OPERATE.
Depress Push Lever
(5) Separate the push lever from the wood.
Next, point the nailer downward, pull the trigger and
then wait in that position for 5 seconds or longer.
THE NAILER MUST NOT OPERATE.
Pull Trigger
(6) First pull the Trigger.
Next, depress the Push Lever against the wood.
THE NAILER MUST NOT OPERATE.
(7) 1 Without touching the trigger, depress the push
lever against the workpiece.
Next, Pull the trigger.
THE NAILER MUST OPERATE.
If the screw is left, skip (8)
through (10) and proceed from
(11).
If the screw is attached, the unit can be
operated in SINGLE SEQUENTIAL ACTUATION
MECHANISM.
).
2
Do not pull Trigger
Screw
2018/09/21 15:04:28 2018/09/21 15:04:28