Nailer Operation - Metabo HPT NR 3675DD Manuel D'instructions

(3) Pull the nail feeder (B) back to engage the feeder
knob to the nail strip.
Nail feeder (B)
NOTE:
● Quietly push the nail feeder (B) and feeder knob
against the nail.
If the nail feeder (B) and feeder knob are released
from backward the magazine and bumped against
the nail, the connecting plastic of the nail can be
damaged.
● Use nail strip of more than 10 nails.
● Use an unbroken nail strip with nails of all the same
length.
The Nailer is now ready to operate.
Removing the nails:
Pull the feeder knob backward.
Return the feeder knob forward quietly while pushing
the nail feeder (B).
Pull out nails from the back of the magazine.
Nail feeder (B)

NAILER OPERATION

Read section titled "SAFETY" (pages 3 – 10).
Feeder knob
Feeder knob
Nails
DANGER
● Operators
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
WARNING
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental fi ring.
● Do not use the electrical cord if damaged.
Have it repaired immediately.
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
● Never place your face, hands or feet near
fi ring head when using.
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Remove all remaining fasteners and battery
from nailer when:
1) doing maintenance and inspection;
2) checking proper operation of push lever
and trigger;
English
and others in
21