Loading Nails; Adjusting Air Pressure - Metabo HPT NV 75A5 Manuel D'instructions Et De Sécurité

(8) Disconnect the air hose.
REMOVE ALL NAILS FROM NAILER.
Remove the hook if it is attached.
When the hook is attached, do not operate with
CONTACT ACTUATION MECHANISM.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE ANY TOOLS TO
OPERATE SWITCH.
Set the switching device to the downward position
(CONTACT ACTUATION MECHANISM).
(Set the switching device to the downward position
completely as shown in the diagram. Otherwise, it will
not operate properly.)
Downward position
Switching Device
(9) Adjust air pressure to 70 psi (4.9 bar 5 kgf/cm
Connect the air hose.
THE NAILER MUST NOT LEAK AIR.
(10) With the Nailer o the wood, pull the Trigger.
Next, depress the Push Lever against the wood.
THE NAILER MUST OPERATE.
(11) Next, depress the Push Lever against the workpiece.
Now pull the Trigger.
THE NAILER MUST OPERATE.
(12) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
THE NAILER MUST OPERATE PROPERLY.

ADJUSTING AIR PRESSURE

WARNING
000Book̲NV75A5̲US̲metabo.indb 13 000Book̲NV75A5̲US̲metabo.indb 13
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Press the knob down and swing the nail guide open.
And open the magazine cover.
).
2
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine
Do not exceed
120 psi (8.3 bar
8.5 kgf/cm ).
2
NOTE: Before loading nails in the magazine, adjust
WARNING
Knob
Nail guide
Magazine cover
Magazine cover
Nail holder
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
English
)
2
13
2018/09/21 15:04:28 2018/09/21 15:04:28