Nailer Operation - Metabo HPT NV 75AN Manuel D'instructions Et De Sécurité

(4) 1 Uncoil enough nails to reach the driving hole.
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
First nail
Driving hole
2
Nail Guide
4 Pulling the nails to the right, swing the nail guide
closed.
(5) Close the magazine cover fi rst and swing the nail
guide closed.
(6) Lock the knob correctly.
Knob
Nail guide
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
000Book̲NV75AN̲US.indb 15 000Book̲NV75AN̲US.indb 15
Guide slot
3
4
1
Feeder Guide surface
Magazine cover

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 8).
DANGER
Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
Only person who have read
and
MANUAL should operate the
Nailer.
NEVER point tool at yourself
or others in work area.
Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
Know and understand what trigger system
you are using.
Please read and understand "Methods of
Operation" below.
Before starting work, check the types of
operation to drive nails.
Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
Do not drive nails into other nails; nails can
ricochet and hurt someone.
Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
In order to avoid double fi re or unwanted
ejection of a nail due to bouncing of the
Nailer,
1) do not push Nailer on workpiece with
strong force;
2) take Nailer away from workpiece using
recoil;
3) release trigger quickly when performing
trigger fi re.
When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
English
MUST wear safety
understand this
15
2018/03/22 15:46:40 2018/03/22 15:46:40