Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ACCESSORIES
WARNING
Accessories other than those shown below can
lead to malfunction and resulting injuries.
STANDARD ACCESSORIES
1
2
1 Eye protection ......................................................... 1
2 Nose cap ................................................................. 1
3 Hook ........................................................................ 1
OPTIONAL ACCESSORIES
Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of metabo HPT.
APPLICATIONS
Floor and wall framing
Siding, fencing, decking
Wall and roof sheathing
Mobile home and modular housing construction
Crate and pallet construction
NOTE:
.131" × 3" (3.3 mm × 75 mm) nails cannot be driven
in some cases, depending on the material. Test drive
some of the nails fi rst to check before using.
Aluminium nails may bend when used on hard
surfaces.
Test before use.
10
000Book̲NV75A5̲US̲metabo.indb 10
000Book̲NV75A5̲US̲metabo.indb 10
BEFORE OPERATION
Read section titled "SAFETY" (pages 3 – 7).
Make sure of the followings before operation.
WORKING ENVIRONMENT
3
AIR SUPPLY
... sold separately
(Code No. 877153)
(Code No. 874042)
(Code No. 876212)
1. Power source
2. Filter-Regulator-Lubricator
WARNING
No fl ammable gas, liquid or other fl ammable
objects at worksite.
Clear the area of children or unauthorized
personnel.
DANGER
NEVER use reactive gases or
other
Explosion may occur.
WARNING
Never
connect
Nailer
which
potentially
exceeds
(13.7 bar 14 kgf/cm
) if a regulator fails.
2
Never use non relieving coupler on Nailer.
Use only clean, dry, regulated compressed air as a
power source for this Nailer.
Air compressors used to supply compressed air to
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
).
2
Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............ The fi lter removes moisture and dirt
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
bottled
gases.
to
pressure
200
psi
2018/09/21 15:04:28
2018/09/21 15:04:28
Publicité
Table des Matières
