Nailer Operation - Metabo HPT NP 18DSAL Manuel D'instructions Et De Sécurité

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

English

(3) Push the nails against the uneven surface of the

magazine and insert the nail tips as far as they will go

into the groove of the magazine.

1 Push into groove

Blade Guide Bottom

Magazine

Nail

Bottom of groove

(4) Push the nails in the magazine into the blade guide

with your ﬁ ngers.

(5) Push the magazine cover forward to return it to the

closed position, checking that the nails do not stick

out above the uneven surface of the magazine.

NOTE

● Close the magazine cover gently.

Applying excessive force may result in deformation

of the nail strip, preventing the magazine cover from

closing.

● If the magazine cover is hard to close, check the

groove of the magazine.

Nails sometimes get into the groove. If this happens,

tilt the power tool and remove the nails with a

precision screwdriver or thin bar. In particular, if any

nails get into the hole shown in the cross-section

drawing, remove them through the window in the

back of the magazine.

Each groove of the magazine

The Nailer is now ready to operate.

Removing the nails:

(1) Press the stop lever and pull out the magazine cover.

(2) Remove the nails from the blade guide or magazine.

Nail

Uneven Surface

Groove of the

magazine

Gap

NOTE

● If the strip breaks inside the blade guide, nails may be

● Check carefully inside the blade guide, as it will be

● If nails get jammed and cannot be removed, refer to