Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
NOTE:
If all warnings and instructions are followed, safe
operation is possible with two systems: SINGLE
SEQUENTIAL ACTUATION MECHANISM and
CONTACT ACTUATION MECHANISM.
Always handle nails and package carefully. If nails
are dropped, collating wire or sheet may be broken.
After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of metabo HPT pneumatic
tool lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
ADJUSTING THE NAILING DEPTH
WARNING
Disconnect the air hose from the nailer
before turning the adjuster.
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held fi rmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 DISCONNECT AIR HOSE FROM NAILER
Adjuster
Deep
Deep
Deep
Deep
Shallow
2 If nails are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in half-turn increments.
Turn Adjuster
2
Too Deep
18
000Book̲NV75A5̲US̲metabo.indb 18
000Book̲NV75A5̲US̲metabo.indb 18
2
Too Shallow
3 Stop turning the adjuster when a suitable position is
4 Connect the air hose.
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the adjuster.
CHANGING THE EXHAUST DIRECTION
The direction of the exhaust vent can be changed by
turning the top cover.
15
Disconnect
air hose
Flush
If nails are driven too shallow, turn the adjuster to the
deep side.
Turn Adjuster
reached for a nailing test.
ALWAYS WEAR EYE PROTECTION.
Perform a nailing test.
WARNING
When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
Top Cover
Exhaust
Vent
Flush
2018/09/21 15:04:29
2018/09/21 15:04:29
Publicité
Table des Matières
