Amana AOGD2750 Serie Mode D'emploi page 9

Converting Oven Burners for Use with LP\Propane
Lower burner orifices and air shutters are located behind
front trim. Remove oven trim to convert oven burners.
1. Remove oven doors .
• See "Removing Oven Door" section.
2. Remove screws (3) from each trim piece.
3. Pull trim away from oven.
• Each orifice box has an air channel. Air channel
must be in place before reinstalling trim.
• Reverse procedure to reinstall trim.
C
A—Air Channel
B—Oriface Box
C—Trim
Remove Oven Trim
A
B
A
B
4. Turn (tighten) orifice hood clockwise until snug.
• Do not overtighten orifice hoods. Orifice hoods can
strip.
A
A—Orifice Hood
Converting Oven Burners
5. Replace trim after burner is tested and air shutter is
properly adjusted.
• See "Test and Adjust Oven Burner" section.
Converting Type 1 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic insert
firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of
regulator.
9