Prepare for Self-clean and
Delayed Self-clean Cycle
!
To avoid risk of personal injury, do not touch oven
vents or areas around vents during self-cleaning.
These areas can become hot enough to cause burns.
To avoid risk of smoke damage or fire, clean excess
spills from oven interior.
• A small amount of smoke is normal when cleaning.
Excess smoke may indicate a faulty gasket or too
much food residue has been left in oven. Move birds
and small animals susceptible to fumes or smoke to
another room.
• Do not use cleaning cycle if oven light cover is not
properly in place.
• Remove oven racks and all cooking utensils from oven.
Clean Burner Area
Wear hand protection to avoid injury from sharp edges.
1. Pull oven bottom forward and lift out.
2. Wipe out burner area around burner with cloth and
warm soapy water.
4. Dry area thoroughly. Replace oven bottom.
Burner Area
WARNING
Clean
burner area
Self-cleaning
Self-clean feature uses high oven temperature to clean
oven interior. Only one oven can be cleaned at a time.
1. Prepare oven for self-cleaning.
2. Press CLEAN pad.
3. Press
or
pad to adjust desired amount of
-
+
cleaning time.
• Increase or decrease cleaning time by 5 minute
increments.
• Clean can be set from 2 to 4 hours. Minimum
recommended cleaning time is 3 hours.
• "LOCK" flashes while oven door is locking and
remains in display while door is locked.
• Oven begins to clean automatically.
4. Press OVEN CANCEL pad when finished.
• After oven has cooled to a safe temperature,
"LOCK" no longer displays and door is unlocked.
Delayed Self-clean Cycle
Self-clean feature uses high oven temperature to clean
oven interior. Set oven to begin and end cleaning at later
time using. Control calculates back from end time to
determine starting time. Only one oven can be clean at a
time.
1. Prepare oven for self-cleaning.
2. Press CLEAN pad.
3. Press
or
-
pad to adjust desired amount of
+
cleaning time.
• Increase or decrease cleaning time by 5 minute
increments.
• Clean can be set from 2 to 4 hours. Minimum
recommended cleaning time is 3 hours.
4. Press STOP TIME pad.
5. Press
or
pad until desired stopping time
-
+
appears in display.
• Starting time is automatically calculated back
based on amount of cleaning time and stop time.
Oven begins to clean automatically.
• "LOCK" flashes while oven door is locking and
remains in display while door is locked.
• To view remaining cleaning time, press and hold
CLEAN pad.
• To view calculated stop time, press and hold STOP
TIME pad.
6. Press OVEN CANCEL pad when finished.
• After oven has cooled to a safe temperature,
"LOCK" no longer displays and door is unlocked.
Interrupt Self-Clean Cycle
1. Press OVEN CANCEL pad.
2. After oven has cooled to a safe temperature, door
can be opened.
21