Testing For Gas Leaks; Test Oven Burner Flame; Adjust Oven Burner Flame - Amana AOGD2750 Serie Mode D'emploi

Testing for Gas Leaks

After final gas connection is made, turn on manual gas
valve and test all connections in gas supply piping and
oven for gas leaks.
!
To avoid property damage or serious personal injury,
never use a lighted match to test for gas leaks.
1. Place soap suds on connection.
• Bubbles appear if leak is present.
2. If bubbles appear, shut off gas supply valve.
3. Tighten joint if leak is at factory fitting.
• If leak is not at factory fitting, unscrew, apply more
joint compound, and tighten to correct leak.
4. Retest connection for leak after tightening.
• Retest any connections that were disturbed.
Testing for Gas Leaks

Test Oven Burner Flame

Properly adjusted oven burner flames are blue with a
distinct deep blue inner cone approximately ½ inch long.
When using natural gas, flame should not have any yellow
flame when burning. Some yellow flame when burning
LP\propane gas is normal.
Flame should not be visible in the oven cavity when
burning and should not extend into the oven cavity
beyond the removable oven bottom.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner.
WARNING

Adjust Oven Burner Flame

!
To avoid electric shock that can cause personal
injury or death, disconnect main electrical supply to
oven before servicing.
Lower burner orifices and air shutters are located behind
front trim. Remove oven trim to adjust oven burners.
1. Remove oven doors .
• See "Removing Oven Door" section.
2. Remove screws (3) from each trim piece.
3. Pull trim away from oven.
• Each orifice box has an air channel. Air channel
must be in place before reinstalling trim.
• Reverse procedure to reinstall trim.
C
A—Air Channel
B—Orifice Box
C—Trim
Remove Oven Trim
11
WARNING
A
B
A
B