Oil Quantity Control; Taking Care Of The Guide Bar - Stihl MS 201 T Notice D'emploi

English
Always slacken off the chain again after
finishing work. The chain contracts as it
cools down. If it is not slackened off, it
can damage the crankshaft and
bearings.
Short-term storage
Wait for engine to cool down. Keep the
machine with a full tank of fuel in a dry
place, well away from sources of
ignition, until you need it again.
Long-term storage
See "Storing the machine"
22

Oil Quantity Control

Varying cutting lengths, types of wood
and work techniques require varying
amounts of oil.
1
The oil flow can be adjusted as needed
using the adjusting screw (1) on the top
of the machine.
Ematic position (E), medium oil flow –
Turn adjusting screw to "E" (Ematic
N
position)
To increase oil flow –
turn the adjusting screw clockwise
N
To reduce oil flow –
turn the adjusting screw
N
counterclockwise
The chain must always be coated with
oil.

Taking Care of the Guide Bar

2
1
Flip the bar – after each sharpening
N
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
Periodically clean the oil inlet
N
hole (1), oil outlet channel (2) and
bar groove (3)
Measure groove depth – using the
N
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
3
MS 201 T