Stihl MS 201 T Notice D'emploi page 22

English
Hold and start the chain saw
N
When the engine has turned over for the
first time
H
L
Move the Master Control lever (1) to
N
the position warm start n
Hold and start the chain saw
N
20
Once the engine is running
1
Press the throttle trigger lockout and
N
blip the throttle trigger (2); the
master control lever (1) jumps to
run F and the engine begins to idle
H
L
Pull the hand guard toward the
N
handlebar
The chain brake is released – the chain
saw is ready for use.
1
2
H
L
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
At very low temperatures
Let the engine warm up briefly with
N
the throttle slightly open
If necessary, configure for winter
N
operation – see "Winter Operation"
Switching off the engine
Move the master control lever to the
N
stop position 0
If the Master Control lever was moved
from the position warm start n to stop 0
– afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
If the engine does not start
The master control lever was not
returned from the position cold start l
to warm start n in time, the engine may
be flooded.
Move the master control lever to the
N
stop position 0
Remove the spark plug – see
N
"Spark plug"
Dry spark plug
N
Crank the engine several times with
N
the starter – to clear the combustion
chamber
MS 201 T