Winter Operation; Starting / Stopping The Engine - Stihl MS 201 T Notice D'emploi

English

Winter Operation

At temperatures below +10 °C
Remove chain sprocket cover – see
N
"Mounting the bar and chain"
Set shutter to "winter operation" r
N
In the "winter operation" setting, heated
air is drawn in from around the cylinder
and mixed with cold air. This prevents air
filter and carburetor icing.
At temperatures above +20 °C
Always return the shutter to the
N
position for "summer operation" s
Risk of engine malfunction –
overheating!
18
Starting / Stopping the
Engine
The four positions of the Master Control
lever
Stop 0 – engine off – ignition is switched
off
Run F – engine is running or can start
Warm start n – this position is for
starting the warm engine – the master
control lever returns to run when the
throttle trigger is squeezed
Cold start l – this position is for starting
the cold engine
Adjusting the Master Control lever
To adjust the Master Control lever from
run F to cold start l, press and hold
down the throttle trigger lockout and
throttle trigger simultaneously – set
master control lever.
To set the master control lever to warm
start n, first set it to cold start l, then
push the master control lever into the
warm start n position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the master control lever
to jump from the warm start n position
to run F.
To switch off the engine, set the master
control lever to Stop 0.
Position cold start l
if the engine is cold
–
if the engine stalls during opening of
–
throttle after starting
If the fuel tank has run empty
–
(engine stalled out)
Position warm start n
If engine is warm (once the engine
–
has been running for approx. one
minute)
When the engine has turned over
–
for the first time
After ventilation of the combustion
–
chamber, if the engine was flooded
MS 201 T