Control Panel Operation - Antari HZ-500 Mode D'emploi

3. If you have followed the above operation steps, and you still experience low
output, mechanical noise or no output at all, unplug the unit immediately from
the mains. Check the fluid level, the external fuse, the remote control
connection, and the power cable from the wall. If all of the above appears to
be O.K., plug the unit in again. If the hazer still does not function, discontinue
operation or it may result in permanent damage to the unit. Return the
machine to your Antari dealer. Always drain tank before mailing or
transporting this unit.
4. Please detach the cap on the tank if you want to clean the cap.
Do not wipe it directly when the cap is attached on the tank. By doing this you
can avoid the dust fall into the fluid tank and contaminate the haze liquids.
5. Please do not allow magnetic equipments to be close to the haze outlet door of
hazer. Magnetic equipment could cause wrong action of the door sensor.

Control Panel Operation

There are 6 buttons on the control panel. They are Function , Timer , Up , Down ,
Volume and Manual respectively. The function and operation of the controller is
as following:
1. W hen switching the HZ-500 on, the characters, Ready To Haze, will be displayed
on the LCD screen. Pressing Volume button once can activate the hazer
6