Unpacking & Inspection - Antari HZ-500 Mode D'emploi

▪ Never drink haze liquid. If it is ingested, call a doctor immediately. If hazer
liquid comes in contact with skin or eyes, rinse thoroughly with water.
Pay attention to all warning labels and instructions printed on the exterior of
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the
system has arrived intact. Before beginning initial setup of your ANTARI HZ-500
Hazer, make sure that there is no evident damage caused by transportation. In the
event of that the unit's housing or cable is damaged, do not plug it in and do not use
it until contacting your ANTARI dealer for assistance.
Operation & Filling Haze Liquid
1. Place the unit on a flat surface. Plug power cord into a grounded electrical
outlet.
2. Remove the fluid tank cap and pour the ANTARI Haze Liquid into the tank slowly
and carefully to avoid overfilling. (Filling Suggestion: Please add 2 litres haze
liquid in the first time of refill. Since second refill, add 1 litre haze liquid for every
refill.) Make sure the liquid level does not does not exceed the mark on the tank.
3. Please refill haze liquid slowly. Otherwise, the haze liquid may overfill and
damage machine. Basically, every refill process of 1-litre haze liquid must be
separated into 5 times. It means after refilling about
200c.c. haze liquid you have to stop refilling and check the tank.
Please make sure that the last 200c.c haze liquids go through the filter inside the
tank properly before pouring next 200c.c. haze liquids into the tank. (Usually it
takes about 10 seconds for 200c.c. haze liquid to go through the filter)
4. Please use only dealer-recommended high-quality haze liquid . Any other
types of fluids may cause health hazard and damage the unit. Use of any
other liquids may void warranty.
5. Please open the square door on the top of the flightcase before
operation in order to let the haze come out smoothly.
6. Set the power switch to "ON" on the control panel of the machine.
Make sure that the red indicator light is on.
7. There is an intake hole in the back of the flightcase. There are a metal net and a
filter attached on the intake, which can avoid the unit from clogging problem.
Please inspect and clean the metal net and filter periodically.
Caution
1. Always monitor and make sure that there is sufficient haze liquid inside
the tank during operation.
2. When the machine is operated for a longer period of time under open- air
conditions, falling dust/debris might attach to the metal net and filter on the
intake hole. The metal net and filter is serviceable, which means those can be
detached easily by screw driver. Please use water to clean the metal net and
filter periodically. By doing this can avoid dust going into the hazers and
prevent the clogging problem of hazers.
your ANTARI Hazer
5