Antari HZ-500 Mode D'emploi page 8

Note 1: The control of the master unit will override the control of the panel controller when
connecting the haze machine via DMX
Note 2: When hazer is under "DOOR SENSOR ON" mode, if the haze outlet door is not
opened properly, and user try to make the hazer work, the buzzer will beep to warn and
"DOOR CLOSED!!" will be shown on the flickering LCD screen and hazing working will
be stopped until the door is open firmly. On the other hand, if hazer is under "DOOR
SENSOR OFF" mode, above situation will not occur.
Note 3: If the CH-500 LCD screen shows "Out Of Order", the machine's internal temperature is
too high and as a result the thermostat has been set off to shut-down the hazer.
Note 4: Before moving the machine it is important to replace the nozzle by the black rubber
cover and make sure it is press tightly in order to prevent the HZL-1 Haze liquid spill if
the machine is upside down during the transportation.Before reuse the machine, please
put the alumina round shape nozzle back to the machine and make sure it is properly
installed.
to clean the mesh regularly.
2. Check the surrounding temperature at the hazer's place of
installation. If the temperature of the surrounding environment
is too high, please move the machine to a cooler place with
better ventilation.
8