Product Overview; Control Panel Operation - Antari M-4 Mode D'emploi

Product Overview

WDMX / Wireless Reciver
LCD Control Panel
XLR 3-Pin DMX
PowerCon
XLR 5-Pin DMX
Setting Up
Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm
open space at each side of the machine and 5 meters for the output direction of the
machine.
Step 2: Fill the fluid tank with Antari fog fluid.
Step 3: Connect the machine to suitably rated power supply. To determine the power
requirement for the machine refer to the label on the back of the machine.
Always connect the machine to a protected circuit and ensure it is properly
grounded to avoid risk of electrocution.
Step 4: Turn on the machine by connecting the power cord and turning the Neutrik
Powercon. Heat-up takes approximatley 5 minutes. Once the machine has reached
operating temperature, the LCD screen will display "Ready To Fog". Now the machine is
ready for operation.

Control Panel Operation

The machine can be operated with the on-board LCD control panel.
Breaker
4