Remote Control Operation - Antari Z-SERIES Mode D'emploi

If your model includes a mounting bracket designed for overhead installation, it may be installed
floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important
that the fog does not shoot directly at any one's face. Whatever installation method you choose,
do not allow the unit to have more than a 15 degree angle or onclination.
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than the
maximum level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the
external fuse, remote control connection and power from the wall. If all of the above appears to be O.K.,
plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check
the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to
determine the cause of the problem, do not simply continue pushing the remote button, as this may
damage the unit. Return the machine to your ANTARI dealer.
Specification
Model Number
Power Supply
Power Consumption
Output Volume
Tank Capacity
Fluid Consumption
Weight
Dimensions(mm)
Remote Included

Remote Control Operation

Z-8: 10 meter wired multi-function remote control with 5-PIN plug for ANTARI Fog Machine model Z-1200II.
♦
The Interval knob adjusts the time between discharges when the timer function is engaged. The range is
from 10 seconds to 250 seconds.
The Volume knob controls the volume of the fog produced. The range is from 0% - 100% of maximum
output.
The yellow TIMER button controls the timer function. Depress the button to activate. When activated, the
yellow light will turn ON. Adjusting the interval knob will determine the time between fog output (10 – 250
seconds). The duration of output is set at 15 seconds. The volume can be adjusted using the volume knob
to control the amount of fog produced.
The red CONTINUOUS button sets the machine to constant fog production. To activate this function,
depress the red button. The volume knob can be used to regulate the volume of the steady stream of fog
produced.
The green MANUAL button will produce a continuous blast at maximum volume while the button is held
down. When released, the manual function stops and the machine will return to the previous setting; timer,
continuous, or stationary.
Note: The continuous function will override the Timer function. Therefore, if both buttons have been
depressed the Z-1200II will fog continuously. The manual function overrides all functions. When
depressed and held down the Z-1200II will fog at maximum volume for as long as the button is held
down, regardless of the machine's setting at the time.
Performance Note
All fog machines develop condensation around the output nozzle. Because this may result in some
♦
moisture accumulation on the surface below the output nozzle, consider this condensation when installing
your unit.
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
♦
after being turned off.
♦ All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
Z-1200II
AC100-120V, AC220-240V / 50HZ-60HZ
1250 W
ca. 500 m³/min.
2.5 Liter
44 min./Liter
10.9 Kg.
L458 W243 H177
Z-8
4