Dmx Control - Antari SNOW MACHINE S-100II Mode D'emploi

Operation
1. Plug the power cable into a grounded electrical outlet.
2. Turn on the machine by pressing the red power switch on the rear of the unit and make
sure the red indicator which is located above the Power switch is lit.
The units can be controlled by either DMX or the SC-2 volume remote control. See the
respective topics below:
3. Connect the remote control's male 4-pin plug to the machines' INPUT socket and make
sure the red "POWER" indicator is lit.
4. Press ON/OFF button, the IN USE indicator lights up green and the machine is ready to
operate (during this procedure, the machine's fan and motors are operating.)
5. Use the adjustable knob "OUTPUT VOLUME" on the SC-2 Volume Remote controller to
set an output value between 10% to 100%.
6. There's a smaller button "AIR VOLUME" located at rear of the machine used for adjusting
the fan output volume. In general, when the fan output is increased the snow flakes
produced are smaller. In contrast, when the fan output is decreased, bigger snow flakes
will be produced. However, the snow output volume will not be affected.

DMX Control

a) Connect the DMX cord to the DMX-IN socket on the rear of the machine.
b) Test the system by activating the snow system's selected DMX channel. When the
channel value is increased the snow machine should produce snow at a steadily
increasing rate. The unit is OFF when a value between 0-5 is selected. It will reach 100%
output once the channel is set to 255.
DMX Protokoll
DMX VALUE
0-5
6-255
c) Addressing:
Each device occupies 1 channel. To ensure that the control signals are properly directed
OFF
ON
7