Do not use cleaning agents containing abrasive substances or
acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.
Hydro clean
To make it easier to clean the cooking compartment, your
appliance is equipped with the > Hydro clean cleaning aid. An
automatically controlled vaporisation of soapy water loosens
residues and makes it easier to remove them afterwards.
For heavy dirt deposits, you can
leave the soapy water to work for some time before switching
■
on the cleaning aid
rub the dirty areas with detergent before switching on
■
repeat the cleaning aid process after leaving the cooking
■
compartment to cool
Preparation and switching on
Hydro clean only starts when the cooking compartment has
cooled down.
If "Not possible" appears on the text display after the Hydro
clean setting is switched on and • or œ and '– appear
alternately on the temperature display, the cooking
compartment has not completely cooled down.
Wait until the cooking compartment has cooled down and
switch on Hydro clean again.
ã=
Risk of scalding and surface damage!
Never pour water into the cooking compartment when it is hot.
Water vapour will be created and the enamel may be damaged
because of the change in temperature.
Remove the accessories from the cooking compartment.
1.
Carefully pour 0.4 litres of water (not distilled water) with
2.
some detergent into the base trough of the cooking
compartment (figure A).
Close the appliance door.
3.
Switch on the > Hydro clean operating mode.
4.
"Hydro clean in operation" appears on the text display
and '– appears on the temperature display. Once the
cleaning aid has finished, the light switches on and "Hydro
clean complete" appears in the display. A signal sounds.
Press the clock function button to exit the clock function.
5.
A
B
Switching off and rinsing
Do not leave the remaining water in the cooking compartment
for a long time (e.g. overnight).
Open the appliance door and remove the remaining water
1.
with an absorbent sponge cloth (figure B).
Clean the cooking compartment with a sponge cloth, a soft
2.
brush or a plastic saucepan scrubber. Remove any
remaining, persistent residue with a glass scraper for glass
ceramic.
Remove limescale with a cloth soaked in vinegar, then wipe
3.
with clean water and rub dry with a soft cloth. Remember to
dry under the door seal.
Turn the operating mode selector back to the Û position.
4.
After cleaning, leave the appliance door ajar in the stop
5.
position (approx. 30°) for approx. 1 hour to allow the enamel
surfaces in the cooking compartment to dry thoroughly.
Rapid drying
After cleaning, leave the appliance door ajar in the stop
1.
position (approx. 30°).
Set the 3 Hot air to 50°C.
2.
After 5 minutes, switch off the appliance and close the
3.
appliance door.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
ã=
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
ã=
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the aftersales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A).
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
A
B
71