Table Des Matières; Operator Safety Instructions - Amano American Sanders FloorCrafter Manuel De L'opérateur

This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating
or attempting any service or maintenance procedure to your American Sanders machine could result in injury to you or to other
personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine
before using it. If your operator(s) cannot read this manual, have it explained fully before attempting to operate this machine.
All directions given in this book are as seen from the operator's position at the rear of the machine.
EN
Contents
Operator Safety Instructions................................... 3-6
Introduction .................................................................7
Machine Specifications ...............................................7
230V Electrical Schematic..........................................7
Machine Transportation .......................................... 8-9
Machine Setup .........................................................10
Machine Operation ..............................................11-12
Sanding Cuts & Sandpaper. .....................................12
Chatter-Wave Prevention .........................................13
Sander Adjustment Procedure .................................14
Routine Maintenance ...............................................16
Troubleshooting .................................................. 17-18
In this Operation Manual you will find three statements that you must read and observe to ensure safe operation of this machine.
DANGER means: Severe bodily injury or death can occur to you or other personnel if the DANGER statements found on
this machine or in this Operation Manual are ignored or are not adhered to. Read and observe all
DANGER statements found in this Operation Manual and on your machine.
WARNING means: Injury can occur to you or to other personnel if the WARNING statements found on your machine or
in the Operation Manual are ignored or are not adhered to. Read and observe all WARNING statements found in this
Operation Manual and on your machine.
CAUTION means: Damage can occur to the machine or to other property if the CAUTION statments found on your
machine or in this Operation Manual are ignored or are not adhered to. Read and observe all CAUTION statments found in
this Operation Manual and on your machine.
READ THIS BOOK
***This product is intended for commercial use only***

Operator Safety Instructions

Wiring Diagram .........................................................69
Handle Assembly ......................................................70
Base Assembly .........................................................72
Belt Tensioner Assembly ..........................................74
Dolly Assembly .........................................................76
Dust Control Assembly .............................................78
Motor Assembly ........................................................80
Sanding Drum Assembly ..........................................82
Warranty ...................................................................86
3