Removing A Handset; Setting Up A Handset On Another Base; Selecting A Base - Topcom OGATECH OG-S60 Manuel D'utilisateur

6.2

Removing a handset

You can remove a handset with a base to allow another handset to be registered
1. Enter the menu by pressing
2. Select SETUP using the up
3. Press OK
4. Select DEL HANDSET using the up
5. Press OK
6. Enter the 4 digit base PIN code
7. Press OK
8. Select the handset to be removed
9. Press OK to validate
6.3

Setting up a handset on another base

If you want to use a OGATECH OG-S60 handset with a base of another model. The base
must be GAP compatible.
1. To put the base in registration mode, refer to the base user manual.
2. Carry out operations 3 to 10 from the paragraph 6.1.
6.4

Selecting a base

The handsets can be registered up to 4 bases simultaneously.
To select a base:
1. Enter the menu by pressing
2. Select REGISTER using the up
3. Press OK
4. Select SELECT BASE using the up
5. Press OK
6. Select a base or select AUTO using the up
7. Press OK
When selecting the base, the currect selected base in indicated by a blinking base number.
If you select 'Auto' the handset will automatically search for another base when you are out
of range!
7 Troubleshooting
Symptom
No display
No tone
OGATECH OG-S60/TWIN/TRIPLE/QUATTRO
All manuals and user guides at all-guides.com
/OK
and down
and down
/OK
and down
and down
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly
connected
The line is occupied by
another handset
OGATECH OG-S60/TWIN/TRIPLE/QUATTRO
keys
keys
keys
keys
and down keys
Solution
Check the position of the
batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord
connection
Wait until the other handset
hangs up
27