8
Register to a Topcom Butler E300 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
•
If you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler E300 handset and base unit!!
Keep the Paging key on the base unit pressed for 4 seconds. During one minute the base
unit is in register mode and you must do the following to subscribe the handset:
Press Menu button
Select 'Register' Æ Enter the base pin code (0000) and press
the base unit you would like to subscribe the handset to (1-4) Æ The unit will start searching
for the base and when found it will register Æ If the pin is wrong, the handset will restart the
searching for the base Æ When the handset is registered, it will show the handset name and
at the right the handset number.
8.1
Selecting a base unit
You can switch your handset between different registered base units if you have registered
a handset to more then one base. You can manually select the base unit or automatically let
the handset choose the nearest base.
Press Menu button
Select 'Select base. Æ Select 'Auto' or the base number (1-4) by the Up/Down
keys and press
8.2
Removing a handset
You can remove a handset from a base to allow another handset to be registered:
Press Menu button
Select 'Delete HS'. Press OK and select the handset you which to remove (1-4) Æ Press
OK to confirm Æ Enter the pin code (0000) and press
You can only remove existing handsets and others then the one you are
using.
Topcom Butler ME300/Twin/Triple/Quattro
ÆUse the
button to scroll to 'System' and press
ÆUse the
button to scroll to 'System' and press
.
ÆUse the
button to scroll to 'System' and press
Topcom Butler E300/Twin/Triple/Quattro
. Enter the number of
.
Æ
Æ
/
Æ
11