General Operation Control; Chapter 5 Using The Machine; Controls; Figure 15 - Location Of The Controls - tomaga CHROMATIC 250 Manuel De L'utilisateur

4.4

GENERAL OPERATION CONTROL

Before testing, make sure that the tray is fully locked, then try operation,
proceeding as follows:
1. press the start button (ON) and the stop button (OFF) (Fig. 11);
2. check that the product holder tray and the product pusher arm move
smoothly;
3. check the operation and adjust the ribbing using the numbered dial;
4. check the operation of the sharpener;
5. check that the product holder tray can only be removed when the
graduated dial is in the "0" position and that after it has been removed, the
dial remains in this position;
6. check whether removing the blade guard rod causes the machine to stop
operating

CHAPTER 5 USING THE MACHINE

CONTROLS

5.1
The controls are located on the
left side of the base.
1. Graduated dial for
adjusting the cutting
thickness.
2. Stop button (OFF).
3.
Start button (ON).
All manuals and user guides at all-guides.com

Figure 15 - Location of the controls

24