Chapter 7 Maintenance; General Information; Maintenance; Belt - tomaga CHROMATIC 250 Manuel De L'utilisateur

CHAPTER 7 MAINTENANCE

7.1

GENERAL INFORMATION

Before performing any maintenance, it is necessary to:
1. Disconnect the plug from the mains to completely isolate the
machine from the rest of the system.
2. Set the graduated knob that adjusts the ribbing to "0"
7.2

MAINTENANCE

7.2.1 BELT

The belt does not need any adjustment. It must usually be replaced after
3/4 years. For replacement, call the "SERVICE CENTRE".

7.2.2 FEET

Over time, the feet may deteriorate and lose their elasticity, decreasing the
stability of the machine. It then becomes necessary to replace them.

7.2.3 POWER CABLE

Check the condition of the cable regularly and call the "SERVICE CENTRE"
if it becomes necessary to replace it.

7.2.4 BLADE

Check that the diameter of the blade, after considerable sharpening, is
not reduced by more that 10 mm compared to the original diameter.
To replace it, call the "SERVICE CENTRE".

7.2.5 WHEELS

Check that the wheels continue to have their abrasive capacity during
sharpening. If this is not the case, they must be replaced to avoid damage
to the blade, therefore it is necessary to call the "SERVICE CENTRE"
All manuals and user guides at all-guides.com
30