Initial Operation; Mounting The Lower Bar; Mounting The Handlebar - Grizzly Tools BRM 5117-2 A 4in1 Set Traduction De La Notice D'utilisation Originale

fuel tank free of grass, leaves or leak-
ing grease (oil).
• Check the grass catcher regularly for
wear or loss of function.
• For reasons of safety, replace worn
or damaged parts. Replace defective
silencers.
• If the fuel tank is to be drained, do this
outdoors.
• Handle your equipment with care.
Keep the tools sharp and clean to ena-
ble you to work better and more safely.
Follow the maintenance directions.
• Do not attempt to repair the equip-
ment yourself unless you are trained
to do so. Any work not specified in
these instructions is to be carried out
only by customer service centres au-
thorised by us.
• Keep the equipment in a dry place
and out of reach of children. Machines
are dangerous if used by inexperi-
enced people.

Initial operation

Caution! Risk of injury from rota-
ting blades. Carry out work on the
equipment only when the blade is
switched off and stationary.
Before starting the equipment, you must
- Remove the Protective Caps
-

Mounting the lower bar

- Install the handle bar
- Mounting the tool tray
- Install the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- adjust cutting height if required
Mounting the lower bar
1. Fold the lower bar (4) outwards,
together with the handlebar (1).
2. Fasten the lower bar (4) to
the lawnmower with the star
grip screws (7) and carriage
bolts (7a). You can determine
the desired tilt for the bar by se-
lecting one of the two possible
screw positions.

Mounting the handlebar

Make sure that the Bowden ca-
bles (5) are not squeezed when
the grip is installed.
1. Place the handlebar (1) onto the
lower bar (4).
2. Push the thread of the quick-re-
lease lever (3) through the drill
holes from the outside.
3. Screw a nut (3a) onto the thread
of each of the quick-release le-
vers (3).
4. Lock the quick release levers
(3) by pressing them towards
the handlebar (1).
The quick release levers (3)
must rest against the bar in
such a way that tigh-tening can
be carried out with medium
force. Otherwise, the quick
release levers must be turned
clockwise for tensioning them or
anti-clockwise to loosen them.
5. Fasten the Bowden cable (5)
using a cable clamp (6) to the
lower bar (4) (see
GB
).
117