Fitting The Starter Cable; Removing/Attaching The Grass Collection Box; Filling Level Indicator - Grizzly Tools BRM 5117-2 A 4in1 Set Traduction De La Notice D'utilisation Originale

GB

Fitting the starter cable

1. Pull the safety bracket (2) to-
wards the handlebar (1) and
hold it in this position.
2. Slowly pull the starter cable by
the starter handle (24) towards
the bar.
3. Guide the starter cable into the
starter cable guide (23).
4. Release the safety bracket (2).
Removing/attaching the grass
collection box
Caution: Do not operate the
equipment with the grass collec-
tion box (22) or impact protec-
tion (21) installed incompletely.
Risk of injury
Assemble grass collection box
• Put the plastic straps (28) over
the grass collection box rod (29).
Fixing the Grass Collection Box onto
the Equipment:
Prior to using the grass collection
box (22), the mulch kit (26) and
lateral ejection chute (27) must be
removed.(see
1. Lift the rear impact protection (21).
2. Hold the grass collection
box (22) by the carrying handle.
3. Hang the grass collection
box (22) into the grass collecti-
on box attachment (30) on the
rear of the device.
4. Remove the impact protection
(21); it keeps the grass collecti-
on box in place.
118
, ).
Removing/emptying the grass
collection box:
1. Switch off the engine and wait
for the blade to come to a stop.
2. Lift the impact protection (21).
3. Remove the grass collection
box (22) by the carrying handle.
4. Empty the grass collection box
(See chapter "Disposal/
environmental protection").
5. Mount the grass collection box
again.

Filling level indicator

There is a filling level indicator (
the grass collection box (
filling level indicator only works while the
machine is in operation.
GO Flap open: grass catcher empty
STOP Flap closed: grass catcher full
The grass collection box must be
emptied.
Mulchkit
Prior to using the mulch kit (26),
the lateral ejection canal (27) has
to be removed ( see "Lateral grass
ejection"
Attaching mulch kit
1. Remove the gras collection box
( 22) , if used.
2. Lift the impact protection (21).
3. Insert the mulch kit (26) into
the holder and push in the bra-
cket (26a) of the mulch kit (26).
You will hear the bracket (26a)
click into place.
22) on
22a). The
).